IO Card PLC Signal Amplifier Board NPN to PNP Mutual Input Optocoupler Isolation Transistor Output Relay Module
Technical Parameters:
Control voltage: DC3.3-24V
Input current: 5-10mA
Output type: non-contact type
Drive component: P/N channel FET
Maximum output current: 6A
Output voltage: DC5-24V
Operating time: 1ms or less
Reset time: 1ms or less
Maximum switching frequency: 2000Hz
Horizontal group installation: standard rail mounting
Instructions:
Instructions:
X1~X7 are the access terminals of the trigger signal.
S/S is the selection terminal for the high and low levels of the trigger signal.
E.g:
When the trigger signal is high, then the S/S terminal should be connected to the negative terminal corresponding to the trigger signal.
Conversely, when the trigger signal is low, the S/S terminal should be connected to the positive pole corresponding to the trigger signal.
Package includes:
1 x Relay module
IO Card PLC Signal Amplifier Board NPN to PNP Mutual Input Optocoupler Isolation Transistor Output Relay Module See detail
